Explosion Proof / IECEx and ATEX Approved Flameproof Exd / Increased Safety Exe and Restricted Breathing ExnR
Outdoor or indoor use.
For use with braid armoured marine shipboard jacketed or non-jacketed cable.
Provides a barrier seal between the individual insulated conductors within the cable and prevents entry of the products of an explosion into the cable.
Assembly of the cable gland/connector compresses and distributes the compound evenly to effect a barrier seal at the point of entry into the enclosure.
Provides an outer deluge seal to prevent moisture ingress to the cable armour and enclosure. Deluge seal is coloured red to indicate hazardous locations product.
Provides a cable retention and low smoke and fume, zero halogen seal onto the cables outer jacket.
Materials & Finishes
The 753 cable gland/connector is manufactured in Brass (standard), Nickel Plated Brass, 316 Stainless Steel or Aluminum. Brass NPT entries are nickel plated as standard.
UL Listing No: E84941.
Suitable for use in: Class 1, Division 1, Gas Groups A, B , C and D.
Class 1, Zone 2, Gas Groups IIA, IIB and IIC.
AExd IIC and AExe II Class 1, Zone 2.
Flameproof Exd IIC Gb, Increased Safety Exe IIC Gb, Dust Extb IIIC Db II 2 GD
ExnR IIC Gc, Extc IIIC Dc II 3 GD
Certificate No's Sira 06ATEX1295X, Sira 07ATEX4330X and IECEx Sir 06.0082X.
Suitable for use in: Zone 1, Zone 2, Zone 21, Zone 22 and in Gas Groups IIA, IIB and IIC.
Construction and Test Standards:
UL 2225, IEC/EN 60079-0, IEC/EN 60079-1, EC/EN 60079-7, IEC/EN 60079-15, IEC/EN 60079-31.
Ingress Protection: IP66, IP67 and IP 68* (30 metres for 7 days) to IEC/EN 60529 and NEMA 4X. *Additional installation procedures required.
Deluge Protection to: DTS01
Operating Temperature Range: -50°C to +60°C (UL) and -60°C to +80°C (ATEX / IECEx)
Note: 753 cable glands are supplied dual ATEX/UL marked as standard.
Assembly Instruction Sheet: AI 318 (UL, Sizes Os to F).
All dimensions in inches (except*).
Os - F size metric entry threads are 1.5mm pitch as standard with 15mm length of thread. For H size cable glands, a 2mm pitch is supplied as standard with a 20mm length of thread (1.5mm pitch with 15mm length of thread can be supplied) please specify when ordering.
† Smaller value is applicable when selecting the standard NPT entry thread.
‡Sizes Os and O are available with an M16 thread size. For O size with M16 thread, the maximum cable inner jacket diameter is 0.43".
†† UL approved only.